Call now to get tree help like tree cutter, tree clearing, bush lop, shrub remove, stump pruning and plenty of other across USA:


Call now

Call us now +1 (855) 280-15-30










The controls are not in neutral.

Never operate the stump grinder without the shield installed on the traction unit and the chip guard on the grinder. Keep all bystanders at least 9 m (30 ft) away from the work area.

Only use the stump grinder for grinding stumps less than 91 cm (36 inch) treelop.buzz: 79 cm (31 inches). 1) Grind horizontally along the edge of the stump; 2) Lower the grinder slightly into the stump; 3) Grind horizontally down to ground level; 4) Move the grinder forward.

Do not start grinding in the middle of the stump; start grinding at the edge of the stump. Height: cm ( inches). Replace drive belt. Adjust tension of new belt to 8 kg (18 lb) force and 10 mm ( inch) belt deflection at mid-span. Tighten the 4 engine-plate mounting bolts and the 4 bolts securing the rear of the belt guard to the engine.

Turn the control dial counterclockwise to open it.

Install the belt guard and secure it with the previously removed washers and treelop.buzzg Depth: 30 cm (12 inches). SGR Stump Grinder Model No. Serial No. and Up Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your product ready.

This manual identifies potential hazards and has safety messages identified Cutting Depth: 30 cm (12 inches). FormNo. RevA STXStumpGrinder ModelNo SerialNoandUp ModelNoG- SerialNoandUp treelop.buzz OriginalInstructions(EN)A.