Call now to get tree help like tree cutter, tree clearing, bush lop, shrub remove, stump pruning and plenty of other across USA:


Call now

Call us now +1 (855) 280-15-30










If you can't feel it repeat until you can.

item 8 Snap On SB1 Transmission Tail shaft Bushing Installer1 1/2" 8 - Snap On SB1 Transmission Tail shaft Bushing Installer1 1/2"Best Selling in Other Automotive Hand Tools. Heavy Duty 4 in 1 Ball JOIINT Press & U Joint Removal Tool Kit With 4x4 Adapters. out of 5 stars based on product ratings New5/5(2). Jul 18, Joined Sep 8.

2, Posts. #3 Jul 16, There is a tool, all new cars use it today.

If neutral isn't there and the trans still turns in reverse with the levers in neutral you missed the gear.

Or just remove the tail shaft housing but hold the mid plate and don't. make it move at all or you'll lose all the input shaft needle bearings. You will need to disengage reverse gear fork. treelop.buzzted Reading Time: 2 mins.

Apr 30, Bloomington, MN. KD Tools makes a tool for this. (#) (Don't know if it's still available or not. I got one on ebay years ago.) You can use it to pull and replace the tail shaft bushing. Makes it a 5 minute job. maverick said: place the tailshaft in a degree oven & the bushing in the freezerthe coefficient of thermal expansion is.

Jul 15, I am planning to replace the tailshaft bushing while I have the trans drained to replace other seals etc. There was an article I found in one of the vette magazines that gave a pretty good step by step, but I wasnt clear if the trans was a T or treelop.buzzted Reading Time: 4 mins. Jun 04, a bushing driver set is the really way to go since it supports the inside as well as the top of the bushing while driving it in.

Total Queries: 10 Zlib Compression is on.

a tranny shop has the right tool to do treelop.buzz than 5 minutes it takes. a puller can be used as the tail is on the tranny and they have a driver to install it.

the same as a tranny.i wouldnt use a socket or Estimated Reading Time: 5 mins. Dec 11, Trophy Points: Location: Opelousas La. It's just as easy to remove the tailshaft housing from the transmission and remove the bushing standing up, instead of laying under the car. Last one I did, all I used was a screw driver and hammer to remove it, once it was out of the car. Come think of it, I don't see how either of those tools.